conventional samplers where playback gets faster as pitch increases.
Range: -1...+1.
The Speed circular slider determines the playback speed of the wavetable
where 1.0 is the approximate speed of the original sample. Interesting
results are usually achieved with slower playback, rather than with faster
playback.
Range: 0.01...32.
The Octave, Semitone and Cent controls are used to set the Generator's
pitch. Octave sets the Generator pitch in octaves. A range of -3 to +3
octaves is available. Semitone sets the Generator pitch in semitones. A
range of -11 to +11 semitones is available. Cent sets the oscillator pitch in
cents (a semitone is equal to 100 cents). A range of -100 to +100 cents is
available.
The Root control enables you to set the unity note of the loaded sample. If,
for example, you set Center to "C1" and play a C2 the sample will be played
one octave above its original frequency. In the case of the Schrader
Generator, to obtain clean wavetables it's essential that the sample's root
note is set to the same note as the one at which the sample was initially
recorded. Otherwise the Generator will produce rough, harsh sounds.
Range: CO...C6.
Loop Sampler Generator
The CronoX 3's "Loop Sampler" Generator is ideally suited to looping
samples. But again in a more creative way as you used to do.
The user interface for this Generator is divided into two parts: the Settings
window on the left and the Waveform window on the right. These two
sections contain a range of controls which are described below:
C r o n o X 3
User Guide
32
