LinMot 0150-1299, Руководство по установке

Страница: 23 / 40

Installation Guide Linear Motors ENG
NTI AG / LinMot P01-48 EX protected Page 23 / 40
4. If fluid cooling is used, remove headless
screws.
For the stator variant with liquid cooling, the
headless screws must be removed and
replaced with the corresponding threaded
plugs. See additional details in Paragraph 4.8.5
4.3 Mounting the flange
The motor is leveled and attached by means of the mounting threads at both ends of the stator. The hole
pattern is shown on p. 15 in the Dimensions section.
4.4 Mounting the payload to the slider
The load is mounted as a fixed bearing using spherical washers and conical seats (see the section on Slider
accessories / mounting kits)
To avoid shear force on slider and wear on stator, the payload has to be supported by a linear guide.
When attaching the load, the wrench for tightening the load must be used only on the load-
facing side of the slider.
It is important to avoid torsional stress on slider (note figure below).
Slider Thread Max. torque for screw
27 mm M 10 47 Nm