![background image](http://html.mh-extra.com/html/linksys/lapac2600/lapac2600_user-manual_1925219005.webp)
Note
—System power consumption is over 15W. Make sure your PoE switch or injector is
803.2at-capable (PoE+) and provides sufficient power. If your PoE switch or injector is
not 802.3at-capable, use the provided power adapter. If the PoE and AC power adapters
are connected to the LAPAC2600 at the same time, the device will get power from PoE.
Ethernet Port 2
—This is a non-PoE Ethernet port. It can be used instead of Ethernet port 1 but
requires an AC power adapter.
Note
—LAG (Link Aggregation) is enabled by default on Ethernet Port 1 and 2. Refer to
your switch configuration guide, and enable one LAG with LACP (802.3ad Link
Aggregation Control Protocol) on the switch if you intend to plug two Ethernet cables into
switch. In this configuration, it is highly recommended that AC power and PoE be used in
tandem in case of support power failure and/or link failure. If your switch does not support
LAG, you can only use one Ethernet port at a time on your LAPAC2600.
Reset Button
—Press and hold this button for less than 15 seconds to power cycle device. Press
and hold for longer than 15 seconds to reset the device to factory default settings.
Mounting Guide
To avoid overheating, do not install your access point if ambient temperatures exceed 104°F
(40°C). Install on a flat, stable surface, near the center of your wireless coverage area making
sure not to block vents on the sides of the device enclosure.
Wall Installation
1.
Position drilling layout template at the desired location.
2.
Drill four screw holes on the mounting surface. If your Ethernet cable is routed behind the
wall, mark Ethernet cable hole as well.
3.
Secure the mounting bracket on the wall with anchors and screws.
4.
If your Ethernet cable is routed behind the wall, cut or drill the Ethernet cable hole you
marked in Step 2. Feed the Ethernet cable through the hole.
5.
Connect the Ethernet cable and/or AC power adapter to your device.
6.
Slide the device into the bracket. Turn clockwise until it locks into place.
5
Содержание LAPAC2600
