Linkcom SlimDoorPhone 1 button, Руководство пользователя

Страница: 16 / 22

Linkcom France
11 rue du Soleil Levant 92140 CLAMART Copyright © 2012 – Linkcom – Tous droits réservés
16
ATTENTION !!! the deletion is non-reversible!!! Numbers must be programmed again.
5.6 Exit programming
Paramet
er
Value Description Default
Exam.
1 Exam.
2
9 E N D
After dialling 9 the unit will hang up.
If you hang up the phone during programming mode without
press 9, the doorphone will stay in programming mode during 20 seconds.
5.7 System setting
Paramet
er
Value Description Default
Exam.
1 Exam.
2
6# s
Number of fitted buttons
of basic module
The basic module is fitted with 4 buttons as standard, i.e. s = 1 is set up for basic module
with one button and s = 2 for module with 2 buttons. This setting is a factory one, no service
can change it and so it is recommended not to change this parameter.
Note: Connecting to the line the value of this parameter is checked and if not satisfactory for unknown
reasons, so it is set up to s = 4 (fitted with 4 buttons).
ATTENTION !!! This parameter can cause the unit to function incorrectly.
Paramet
r
Value Description Default
Exam.
1 Exam.
2
6 z
Acoustic signalling
3 and 9
3 and
9
3 and
9
In default the unit produces acoustic signals. It can occasionally cause a problem of incorrect
detection of tones by PBX. By changing parameter „
z“ you can switch off this acoustic
signalization. The values are:
z=0 – all signalling is switched off
z=1 – pick up and hang up tones are active only
z=2 – other tones active only
(except pick up and hang up)
z=3 – all tones are active
– (
default)
It is possible to generate an audible signal (only in mode m=1) to alert visitors that the door
is unlocked so that they can enter. This is especially useful when using a DC power source,
as lock release may be silent.
z=8 – signalling is active
z=9 – signalling is unactive
Paramet
er
Value Description Default
Exam.
1 Exam.
2
6
∗
t
Delay of line connection
(Siemens PBX)
1 1 1
Setes a delay for line pick-up (OFF HOOK) for new PBX types (particularly Siemens):
t=1 – standard operation
t=0 – delayed start
5.8 Overview of Parameters
Parameter Value Description Default Exam.1 Exam.2
1 t nn…
No. nn under
button t
- - -