Linkcom SlimDoorPhone 1 button, Руководство пользователя

Страница: 10 / 22

Linkcom France
11 rue du Soleil Levant 92140 CLAMART Copyright © 2012 – Linkcom – Tous droits réservés
10
To program a parameter, enter the parameter number followed by the value you wish to
set. The unit will either respond with the Parameter Confirmation Tone, or one of the Error
Tones.
Note 1 .
if you wish to maintain the connection in programming mode (i.e. extend the 34 seconds
period) then it is necessary to occasionally press a key (e.g. *, # or 7). The unit will respond with an
error tone but the connection will be kept alive.
Note 2.
The # sign is not used in the values for parameters 32,33 and 34, and can be used to
immediately save the parameter.
Note 3.
If you hang up the phone during programming mode without press 9, the doorphone will stay
in programming mode during 20 seconds.
4.2 Programming from a PC – ID Manager program
To setup the unit from a PC you will require a special USB tool cable, available separately,
and must first install the USB driver and ID Manager software. Refer to the CD for more
details. The unit must also be connected to the telephone line.
Procedure:
-
Connect the ID Doorphone to the line
-
Connect the unit to the PC with the USB tool cable.
-
Run the ID Manager program. The unit will enter PC programming mode and emit the
Enter Programming tone (see chapter 3.1). If connection is lost, it is necessary to
disconnect the USB cable from unit and connect it again. The unit will answer and,
providing the ID Manager program is running, it will confirm its entry into programming
mode again.
Refer to the ID Manager manual for more details.
5 Parameter description
5.1 Direct Dialling – Memories
Parameter Value Description Default Exam.1 Exam.2
1 t nn…
No. nn under
button t
- - -
USB – PC
connection
USB – tool
Small
connector