7
Assembling the Microscope
Slide Holder
The Microscope Slide Holder (1) is supplied
separately from the stage. Fix the holder to the
LTS120 stage, by following the instruction below.
Remove the screw (2).
Make sure the 2 holes on the Microscope Glass
Slide Holder are lined up with the two notches (3)
on the XY Manipulator Assembly and place the
holder in place.
Use the screw (2) to fix the Microscope Slide
Holder in place.
Note: when fitted properly the Microscope Slide
Holder should not touch the silver heating block
(4), the holder should hover about 1mm above it.
If the holder is touching the silver block or hovers
too high, remove screw (2) and flip the Micro-
scope Slide Holder over.
Note: the Microscope Slide Holder can be bent
into shape with a little force to help.
1
3
4
2
