Linhai ARCHON 400, Руководство по обслуживанию

Страница: 167 / 218

CHAPTER 6 TRANSMISSION
BUCK 450 SERVICE MANUAL 20.0
CHAPTER 6 TRANSMISSION PAGE. 6- 11
13. Prior to reinstalling the cover make sure the mating
cover surfaces are clean and dry, and shafts are
fully seated in transmission case. Apply silicon to
mating surfaces.
14. Reinstall main cover and torque bolts in a cross
pattern in 3 step to 14 ft.lbs. (20Nm).
15. Install new input shaft seal.
16. Install drain plug with a new sealing washer. Torque
drain plug to 14 ft.lb. (19Nm).
17. Install transmission and add 80W/90 oil in the
recommended amount. Refer to Maintenance
Chapter.
18. Install gear indicator switches. Apply LoctiteTM 242
(blue) to threads of switch screws and torque to
13-16 in. lbs. (1.5-1.9 Nm).
6.9 TROUBLE SHOOTING CHECKLIST
Check the following items when shifting difficulty is encountered

Idle speed adjustment
 Transmission oil type/quality
 Driven clutch (CVT) deflection
 Loose fasteners on rod ends
 Loose fasteners on gear shift box
 Worn rod ends, clevis pins, or pivot arm bushings

Linkage rod adjustment and rod end positioning
 Shift selector rail travel
 *Worn, broken or damaged internal transmission components
Check the following items when transmission locked
 Gear shifter malfunction (Selector lever end come out from slides notches), engage the
Hi and Lo Gear at the same time.
NOTE: To determine if shifting difficulty or problem is caused by an internal transmission
problem , isolate the transmission by disconnecting linkage rods from transmission bell cranks .
Manually select each gear range at the transmission bell crank, and test ride vehicle. If it
functions properly, the problem is outside the transmission.
If transmission problem remains, disassemble transmission and inspect all gear dogs for wear
(rounding), damage. Inspect all bearings, circlips, thrust washers and shafts for wear.