Linhai ARCHON 400, Руководство по обслуживанию

Страница: 142 / 218

CHAPTER 5 FINAL DRIVE
BUCK 450 SERVICE MANUAL 20.0
CHAPTER 5 FINAL DRIVE. 5- 20
Fig 4
5. Apply some Loctite 510 silicone sealant on
the
shaft neck of pipe joint N for the
installation .
Mount the pipe joint N on the suited hole of
the rear gear case G.
→Fig 5
Fig 5
6. Mount the shaft neck of the bevel gear
comp.-driven
E in the suited hole of the
needle bearing H.
Make the ring gear bearing housing C and
the rear gear case G together
→Fig 6
Fig 6
7. Tighten the six bolts M8×25 Q to a torque of
20~25N.m .
Tighten the two bolts M10×1.25×25 P to a
torque of 35~40N.m .
8. Mount the axle sleeve U of the inner & outer
race in the neck of the bevel gear-driving V.
→Fig 8
Fig 8
9. Mount the bearing W into the suited hole of
the bevel gear bearing housing Z.
Mount the bearing retainer X in the bevel
gear bearing housing Z with the special tool ，
tight securely (90~100N.m) .
Mount the O-ring a into the groove of the
ring gear bearing housing Z.
Mount the oil seal Y into the suited hole of the
bevel gear bearing housing Z.
→Fig 9