English Manual
English 6
Configuration
DHCP
After switch-on
LINDY IPower Control
looks for a DHCP server and requests an available IP
address (for deactivation of that feature see 2.2). Please check the IP adress allocated to
LINDY IPower Control
in the DHCP server settings to make sure that the same address is
used at every reboot.
Network settings with GBL_Conf
For changing thework properties manually, the program GBL_Conf.exe is required. This tool is
available for free on our website www.lindy.com. Furthermore GBL_Conf.exe enables you to
install firmware updates and to reset
LINDY IPower Control
to its factory settings. Activate
bootloader mode of
LINDY IPower Control
and run GBL_Conf.exe. The program will look
automatically for connected devices and will display theirwork configuration.
If the displayed IP address accords with the factory settings (192.168.0.2), there is either no
DHCP server available in thework or no free IP address could be allocated. Enter a free IP
address and the accordingmask in the entry mask, then save these changes by clicking on
Program - Device - SaveConfig.
Restart the firmware of
LINDY IPower Control
, so that the changes will take effect. Now click
on Search in order to have thenewwork configuration displayed.