English Manual
English 14
Batchmode
Each Power Port of
LINDY IPower Control
can be switched on or off with a selectable delay (1-
30 sec. or 1-30 min.). After the chosen delay the selected port will be switched off/on again
automatically
.
Optionally the device can be accessed by using the perl script „EPC_Control2.pl” through the
command line (e.g. for automatic or time-triggered switching).
Switching via serial interface
Alternatively to the Ethernet interface, the Power Ports of
LINDY IPower Control 4x DIN
can be
switched through its serial interface. It only requires a terminal program like HyperTerminal, a
program provided under Windows for free (to be found under Programs -> Accessories ->
Communication). Connect your PC with
LINDY IPower Control 4x DIN
by a 9- pole serial cable
(RS232) and plug the device into a outlet. Now you can turn on
LINDY IPower Control 4x DIN
.
The boot process lasts a few seconds longer than by Ethernet. You can access
LINDY IPower
Control 4x DIN
through the terminal program as soon as the status LED shines green. Choose
the COM port that is connected to
LINDY IPower Control 4x DIN
and enter the following values
for the serial interface:
If you do not use HyperTerminal, please make sure
that the terminal program supports VT100
commands.
After having connected successfully
, LINDY IPower
Control 4x DIN
answers as shown in figure below.
Press Enter for login.
Now the Power Ports can be switched on and
off per number keys. By pressing c you can
check thework configuration and by pressing
Esc you can log out.