Lindsay Transportation Solutions Sales and Services, Inc
(888) 800-3691 [U.S. toll free] or +1 (707) 374-6800
Lindsay Transportation Solutions Sales and Services, Inc
(888) 800-3691 [U.S. toll free] or +1 (707) 374-6800
36
Page 36
U n i v e r s a l T A U - I I
®
C r a s h C u s h i o n
T A P E R E D S Y S T E M
STEP 6
Attach Nose Piece / Delineation Marker
Narrow systems (up to 36” [910mm] Front Support)
use a one-piece polyurethane nose (Figure 24) with
molded thrie beam corrugations on both ends. Wider
Front Support Assemblies (42” [1070mm] and above)
use two polyurethane parts (Figure 25) riveted
together. The two part nose pieces have thrie beam
corrugations on one side and a series of holes
through the flat section. Guide Cable Torque
The Nose Piece attaches to the Front Support
assembly through the Sliding Panels (Figure 26).
Thick flat round washers are inserted in the mounting
holes of the nose piece to limit compression of the
polyurethane. Two ¾” [20mm] bolts with fender
washers clamp the nose piece and Sliding Panel to
the Front Support on each side. Fasteners use lock
washers or Locktite.
Torque to 200 ft-lbf [270 N-m].
The two part nose pieces overlap across the width of
the system. Adjust to desired profile and align holes.
Using the supplied pop-rivets and washers, rivet two
columns of holes. Rivets should pass through the
overlapping nose pieces at the furthest possible
columns apart (Figure 26).
Apply delineation markings as required (not
supplied).
Figure 26 Wide Nose Piece Assembly
Figure 24 Nose Piece (up to 36”)
Figure 25 Nose Piece (wide)
