LINDR KCH 01584, Инструкция по эксплуатации

Страница: 24 / 36

24
16. Putting into Operation
1. Connect air supply and beverage supply according to point 13.
2. Set the thermostat to 0 position.
3. Connect the cooler to the power mains.
4. Tap the keg in accordance with point 15.
5. Turn the air compressor on using the switch and pressurise it to the
required pressure of 1.0-3.4 bar (in models with built-in
compressor, pressure is automatically set to 2.8-3.4 bar).
6. Check that all the joints and connections are sufficiently tightened.
WARNING:
If leakage is found, untap the keg according to
point 15 and turn off the device. Fix any leaks found on the tubing.
If a leak is found inside the device or you are unsure how to
proceed, contact a service centre.
7. Use the bar tap to pour out some of the beverage and check that
there is no water left in the device.
WARNING
: If there is water in the device, do not turn it on.
The water might freeze in the beverage tubing and damage the
device.
8. Set the desired temperature on the thermostat – see point 18.
9. The beverage is now cooling; once cooled (ca. 5-10 minutes) you
can start pouring the first drink.