The control is provided by default fitted on the appli-ance,
however it can also be remoted by fitting it on the wall.
Always disconnect power
before accessing the unit.
1- Remove the controller from the front panel using the
suction cup accessory.
2- Remove the 3-pole connector coupled to the controller.
1
1a
3- Unscrew the top cover to access the electric
compartment where the power board is located.
4- Remove the cable connected to the CONTROL
connector (
terminals 1-2-3
) of the power board.
2
3
CONTROL
1 2 3
4
5-
Perform the new connection to position the con-troller
on the wall, respecting the sequence of the terminal
numbers:
a)
apply the supplied cable gland as indicated in the
figure
;
b)
fix the cable in the cable gland
;
c)
connect the cable to terminals1-2-3 from the power
board to the controller respecting the numbers
CONTROL
PG7
Lindab reserves the right to make changes without prior notice
202
2
-0
1
-
28
RHR-CF
lindab | we simplify construction
Installation instructions
10.3 Connection with remote control
Fig. 14
2
0
