Lindab InCapsa, Инструкция по монтажу

Страница: 6 / 20

6
l i n d a b | we s i m p l i f y c o n s t r u c t i o n
Rails and consoles
Mounting consoles
1. Mark the wall and the ceiling where the consoles are to be attached. The easiest way
to locate the position of the fixing hole is to use a console. Be sure to hold the console
close to both the ceiling and the wall to prevent the installation being skewed.
2. The holes should be positioned as far from the wall and ceiling as the elongated holes in
the console allow. Each rail requires a minimum of two consoles.
3. The first console is attached 300 mm from the wall where the installation begins, with
the next being sited at an appropriate distance to hold both ends of ceiling- and wall
rails.
4. Drill holes in the ceiling and the wall and use suitable plug if necessary. Each console
requires two screws, one in the ceiling and one in the wall.
5. Do not tighten the screws fully; leave them loose so that the console can move and
there is room to insert the upturned edge of the rail into the cut-out slot in the console.
Cutting rails
1. Measure the room carefully and determine how long all rails must be. Mark on the rail
where you need to cut it.
2. Cut the rails to size using metal shears. Start by cutting the portion of the rail folded in
two up to the short side of the rail until you hear a click.
3. Then cut the upturned edge and long side.
4. Bend the rail back and forth on the short side of the rail until it breaks. Straighten the
edge using a pair of pliers if it has become deformed.