Lindab InCapsa, Инструкция по монтажу

Страница: 10 / 20

10
l i n d a b | we s i m p l i f y c o n s t r u c t i o n
Holes for duct system
1. On the side of the panel, mark where the hole is to be located.
2. Use a fitting with the same dimension as the duct system inside the panel as a
template. Place the fitting at the correct distance from the top edge of the panel as
shown in the table below and draw the outline of your hole using a marker pen.
3. Drill a 10 mm hole about 10 mm from the line. Use metal shears and cut a smaller
hole. Then cut the entire hole to the appropriate size, large enough to allow a fitting to
pass through.
Panel dimension Duct dimension Distance from top of the panel to the fitting
100 100 24
125 100 44
125 125 24.5
160 100 77
160 125 61.5
160 160 26
6. Attach two inner joints to the end of the final panel .
7. Hold the final panel between the already attached panel and the wall and mark where it
should lie against the inner joints.
8. Using a square, mark on the panel where you want to cut it and then use the nibbler to
cut. Straighten the edge using a pair of pliers if it has been deformed.
9. Remove the protective film from the panels.
10. In order to make it easy to remove a panel, the inner joints on both sides of the panel
must not be attached to the panel you wish to remove.