Note:
If it appears that automatic control of the high beams is not
functioning properly, check the windshield in front of the camera for
blockage. A clear view of the road is required for proper system
operation. Any windshield damage in the area of the camera field-of-view
should be repaired.
Note:
If a blockage is detected (e.g. bird dropping, bug splatter, snow, or
ice) and no changes are observed, the system will go into low beam
mode until the blockage is cleared. A message may also appear in the
instrument cluster display noting the front camera is blocked.
Note:
Typical road dust, dirt and water spots will not affect the
automatic high beam system’s performance. However, in cold or
inclement weather conditions, the automatic high beam system’s
availability may be decreased. If the driver wants to change the beam
state independently of the system, the driver may turn the high beams
on or off using the multifunction switch stalk. Automatic control will
resume when conditions are correct.
Note:
Modification of the vehicle ride height (e.g. using much larger
tires) may degrade feature performance.
A camera sensor is centrally mounted behind the windshield of the
vehicle, and monitors the conditions to decide when to switch the high
beams off and on.
Once the system is active the high beams will switch on if:
•
The ambient light level is low enough that high beams are needed.
•
There is no traffic in front of the vehicle.
•
Vehicle speed is greater than 25 mph (40 km/h).
•
Severe weather is not detected.
The high beams will switch off if:
•
An approaching vehicle’s headlights or a preceding vehicle’s tail lamps
are detected.
•
The vehicle speed falls below 19 mph (30 km/h).
•
The ambient light level is high enough that high beams are not
needed.
•
Severe rain, snow or fog is detected.
•
The camera is blocked.
90
Lighting
2014 MKS
(mks)
Owners Guide gf, 1st Printing, April 2013
USA
(fus)
