You may also program a personal entry code through the MyFord Touch
or MyLincoln Touch system. Refer to the
MyFord Touch
or
MyLincoln
Touch
chapter.
Tips:
•
Do not set a code that uses five of the same number.
•
Do not use five numbers in sequential order.
•
The factory-set code will work even if you have set your own personal
code.
Erasing a Personal Code
1. Enter the factory-set 5-digit code.
2. Press and release
1
•
2
on the keypad within five seconds.
3. Press and hold
1
•
2
for two seconds. This must be done within five
seconds of completing Step 2.
All personal codes are now erased and only the factory-set 5-digit code
will work.
Anti-Scan Feature
The keypad will go into an anti-scan mode if you enter the wrong code
seven times (35 consecutive button presses). This mode disables the
keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
•
one minute of keypad inactivity
•
pressing the unlock button on the remote control
•
the ignition is turned on
•
unlocking the vehicle using intelligent access.
Unlocking and Locking the Doors
To unlock the driver door:
Enter the factory-set 5-digit code or your
personal code. You must press each number within five seconds of each
other. The interior lamps will illuminate.
Note:
All doors will unlock if
the two-stage unlocking feature is disabled. Refer to
Locking and
Unlocking
earlier in this chapter.
To unlock all doors:
Enter the factory-set code or your personal code,
then press
3
•
4
within five seconds.
To lock all doors:
Press and hold
7
•
8
and
9
•
0
at the same time with
the driver door closed. You do not need to enter the keypad code first.
Locks
73
2014 MKS
(mks)
Owners Guide gf, 1st Printing, April 2013
USA
(fus)
