CounterTop - 1300 Series Ops Manual
16
IMPINGER
®
FINGER COLUMNATING PLATES (CONT’D)
NOTE: The Impinger
®
CounterTop was built with the basic idea that it would be ready out of the box – uncrate,
plug-in and cook! In all but 5% of your cooking applications you will do just that. You will not need to alter the ICT
set-up except for very special requirements.
Our objective here is to tell you about these alternate panels because they have gone through the “new product
release” process and are available to you for special applications in the field. As always, the Product Manager and
the Applied Technology Department will be here should you need further information or guidance.
COLUMNATING PANEL #1349
APPEARANCE: Panel is made from solid metal with 6 rows of larger
holes, then covered with perforated metal.
EFFECT: Reduces air flow significantly. A relative comparison can
be made between a 1349/1736 (Low Profile).
COLUMNATING PANEL #1355
APPEARANCE: Panel is made from perforated metal. It has no
large orifice columnating holes.
EFFECT: Moderate velocity. A relative comparison can be made
between a 1355/1511.
COLUMNATING PANEL #1356
APPEARANCE: Panel is made from solid metal with only 2 rows of
holes open in one side of the panel; then the open holes are
covered with perforated metal.
EFFECT: Extreme reduction in airflow, 67% less than a #1349.
COLUMNATING PANEL #1360
APPEARANCE: Panel is made from solid metal with 6 rows of holes.
EFFECT: Less velocity than a #1368 or a #1355. A relative
comparison can be made between a 1360/1500.
COLUMNATING PANEL #1361
APPEARANCE: Panel made from solid blank plate, no holes.
EFFECT: This panel would create a complete block of air from any
one finger in the Impinger
®
CounterTop. A relative comparison can
be made between the 1361/1501.
CAUTION:
The smaller the interior chamber, the more critical the airflow balance. A panel change
in the ICT may cause front to back striping discrepancies for certain applications.
!
