English 5 English
Installation and Operator Instructions
General description
SPEEDTEC 320CP
is a manual welding set that
enables the following:
MIG-MAG welding with short arc, speed short arc,
spray-arc, normal pulsed mode using currents from
15A to 320A.
SPEEDTEC 320CP work with the water cooler
COOLARC 46.
Feeding different types of wire
-
steel, stainless steel, aluminum and special wires
-
solid and cored wires
-
diameters from 0.6-0.8-1.0-1.2 mm
WELDING SET COMPONENTS
The welding set consists of 4 main components:
1. power source including its primary cable (5m)
without plug
2. gas hose kit assembly (2m)
3. work lead (3m)
4. rolls for solid wire V1.0/V1.2
5. USB key containing Instruction Manual
Recommended equipment, which can be bought by
user, was mentioned in the chapter "Accessories".
Read this entire section before installation or operation of
the machine.
WARNING
The plastic handles are not intended for slinging the set.
Stability of the equipment is guaranteed only for an incline
of maximum 15°.
Location and Environment
This machine will operate in harsh environments.
However, it is important that simple preventative
measures are followed to assure long life and reliable
operation.
Do not use this machine for pipe thawing.
This machine must be located where there is free
circulation of clean air without restrictions for air
movement to and from the air vents. Do not cover the
machine with paper, cloth or rags when switched on.
Dirt and dust that can be drawn into the machine should
be kept to a minimum.
This machine has a protection rating of IP23. Keep it
dry when possible and do not place it on wet ground or
in puddles.
Locate the machine away from radio controlled
machinery. Normal operation may adversely affect the
operation of nearby radio controlled machinery, which
may result in injury or equipment damage. Read the
section on electromagnetic compatibility in this manual.
Do not operate in areas with an ambient temperature
greater than 40°C.
DUTY CYCLE AND OVERHEATING
Duty cycle is the percentage of 10 minutes at 40°C
ambient temperature that the unit can weld at its rated
output without overheating.
If the unit overheats, the output stops and the over
temperature light comes On. To correct the situation,
wait fifteen minutes for unit to cool.
Reduce amperage, voltage or duty cycle before starting
to weld again
.
STARTING UP
The power source is composed with :
1 - Front panel display
2 - European plug for torch
3 - Additional plug for 2 potentiometers torch
4 - Plug for ground cable and polarity inversion
5 - Protection door for wire feeder section
6 - Spool axle, shaft, axle nut
7 - Gas purge button
8 - Cold wire feeding button
9 - Wire driver
Input Supply Connection
WARNING
Only a qualified electrician can connect the welding
machine to the supply network. Installation the outlet plug
to power lead and connecting the welding machine had to
be made in accordance with the appropriate National
Electrical Code and local regulations.
Check the input voltage, phase, and frequency supplied
to this machine before turning it on. Verify the connection
of grounding wires from the machine to the input source.
SPEEDTEC 320 CP
can only be connected to a mating
grounded receptacle.
6
5
7
8
9
1
4
2
3
