English 10 English
Program management
SPEEDTEC 320 CP
allows creating, storing and modifying up to 99 welding programs directly on front panel from program 01
to program 99. This function is activated by moving parameter PGM from no to YES in COnFIG menu.
P00 is the working program in any state. (Program management mode activated or desactivated). When power source is
working on this program, the Led indicator “JOB” is switched off. All commutators are accessible in this mode, so it will be
used to set programs.
P01 to P99 are program saved, only if program management mode is activated. When power source is working on these
programs, the led indicator “JOB” is switched on. In this mode, commutators welding process, wire diameter, gas and metal
are not available.
When a program selected has been modified, the indicator “JOB” blinks.
Create and save a program
:
These paragraphe explains how to create, modify and save a welding program. Hereunder is explained the common menu used.
1) Activate program management mode:
PGM
put YES
exit
2) Set your program with the 4 commutators (4) and (11) then long push
3) Screen displays message as following:
Program call with trigger
This function allows to chain from 2 to 10 programs. This function is available in 4S welding mode only and program management
mode has to be activated
Program chaining
:
The function program call works with programs from P50 to P99 by ten.
P50
P59 ; P60
P69 ; P70
P79 ; P80
P89 ; P90
P99
Select first program with which you want to begin your chain. Then during welding, each time you will push trigger, program will
change.
To chain less than ten programs, in the program following end of loop desired put a different parameter (As synergy or welding
cycle).
It is possible to setup time of trigger push to detect change of program chain :
CPT
put value from 1 to 100
exit
Example
: Create a program list from P50 to P55 (6 programs).
1)
In program P56, put different welding cycle or synergy than P55 in order to finish chain
2)
Select program P50 (First program for start of welding
3)
Start
welding
4)
Each time trigger will be pushed, power source will change program until P55. When chain is finished, power source will
restart to P50.
Program number
selection.from P01
to P99.
P00: Cancel
program mode
Function selection:
rEC: Save program
Ld: Load program
cod: Activate
locking code
Validate
action in
progress
Cancel action
in progress.
