Lincoln Electric Prince XL, Руководство оператора

Страница: 12 / 53

Prince XL - Owner's Manual - Page 5
W
ATER
H
OSE
The water hose (if so equiped) is secured over the barbed water fi tting with
a tie wrap, in the torch body. The loose end connects to the return line of
the recirculator.
E
LECTRIC
C
ABLE
A seven conductor control cable is used on the Prince
®
XL Torch. The torch
end of the control cable is secured to the torch with a boot clamp and plugged
into the pot assembly and micro switch connectors. Slack is left in the electric
cable as it exits the back of the torch to prevent cable breakage. The cabinet
end has a seven pin "W" clocked amphenol connector. See page 22 for torch
electrical connections.
I
NSTALLING
S
POOL
A
SSEMBLY
(P/N 003-2090)
Loosen the screw that secures the conduit through access hole located on
top right rear handle with a 1/16" Allen wrench.
Remove conduit by pulling it out of the back of the gun.
Install spool liner, and secure with screw.
Remove both rear handle screws, and secure spool canister with longer
screws provided.
S
POOL
G
UN
S
ETUP
L
OADING
E
LECTRODE
W
IRE
Unscrew, and remove spool cover.
Apply tension to drive rolls, so the wire will be picked up and fed through
the contact tip.
Straighten out fi rst six inches of wire and push through liner.
Jog trigger until wire is picked up by drive rolls and fed through contact tip.
Hold brake assembly back towards top of gun, load spool onto shaft with
wire coming off the bottom of the spool. Release brake assembly to rest
on wire surface.
Replace spool cover, making sure opening is over liner.
Note:
The brake paddle assembly is designed to automatically control spool drag and
keep the wire from jumping off the spool.
Conduit Securing Screw
E-Ring
Rear Wire Guide
Spool Liner
2 Screws