IS91SE_ECN 3592
6
NOTE: The OG7401 chargrill has two sets of controls and dual pilots. Ensure that both pilots
are lit before lighting the main burners.
7)
To light the main burner, turn the control knob anti-clockwise to the high setting. On the
high setting, the chargrill will take approximately 20 minutes to achieve full working
temperature from cold.
NOTE: This appliance must not be used (or left) with the control knobs positioned between
the pilot position and the full on position.
8)
To run the appliance on low, turn the control knob
fully anti-clockwise to the LOW setting.
9)
The heat input can now be adjusted between High and Low settings to give the desired
working temperature.
10)
Repeat steps 7 – 9 to light the second set of burners.
Warning: Never attempt to light the burners through the heat transfer fins.
Standby
Once the pilots are lit whole or part of the unit can be left on standby by leaving the control knob in
the pilot position. The pilot light(s) will remain lit but the burners will be shut down.
Shutting down the appliance
To turn the appliance off completely turn the control knob(s)
clockwise to the to the OFF position.
Warning: After operation, some parts of the appliance will remain hot for a period of time.
Please take care to avoid accidental burns.
Cleaning
Ensure gas supply is isolated before commencing cleaning.
After complete shut down and cooling, parts of this unit can be dismantled for cleaning, in the
following order: Refer to Assembly of Enclosures diagram.
Branding plates
x 4
Splash surround
x 1
Heat transfer profiles
x 9
Drain tray
x 1
Profile support arms
x 2
Fat collection drawer
x 1
Flue cover
x 1
Debris tray
x 1
All parts can be cleaned in a commercial dishwasher, with the exception of the fat collection drawer
which should be washed by hand.
The unit, including burner covers and internal surfaces, can be cleaned using warm detergent
solution.
Take care not to allow water or traces of detergent to remain on the burners.
Do not use abrasives
Do not use any products containing chlorine to clean stainless steel surfaces.
