IS91SE_ECN 3592
5
Positioning of heat transfer channels.
Lighting the Appliance
Please ensure that the gas isolation valve for the appliance is turned to the open position before
attempting to light this unit.
1)
Pass the piezo ignitor wand through the access holes in the rear of the drain tray and
down
the ignition guide channel until it reaches the stop point.
2)
With the control knob in the OFF position, depress the control knob fully, to allow gas
through to the pilot burner, hold in and turn anti-clockwise to the pilot position.
3)
Slowly click the Piezo ignitor wand until the pilot is lit.
4)
Keep the control knob depressed for 20 seconds to establish the pilot light.
5)
Should the pilot fail to remain lit, return the control knob to the OFF position and repeat the
process.
6)
Repeat steps 1 –5 to light the pilot to the second set of burners.
MOVE BRANDING PLATE AND PLACE PIEZO IGNITER INTO
LIGHTING GUIDE. CLICK SLOWLY. REPEAT FOR OTHER SIDE.
A
DETAIL A
FORWARD FACING
REARWARD FACING
CENTRAL PROFILE
FRONT
BACK
