LIN 32D1700, Руководство пользователя

Страница: 10 / 40

10
Switching on
Follow the instructions on this page on how to switch on your TV
set and the remote control before going on to following pages
describing how to use the channel set-up procedure.
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
-
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat such as sunshine,
try to
open them, as this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not
using it for a long period of time.
2. Connect the power cable FIRST to the television, THEN to a
mains socket.
(Note: If the power cable is connected to the television, please
only connect the power cable to the mains socket.)
Your TV set should only be connected to an AC supply. It must
not be connected to a DC supply. If the plug is detached from
the cable, do not, under any circumstances, connect it to a
mains socket, as there is a risk of electric shock.
the power socket of the television might differ depend on the
model.
3. Connect an outside aerial to the ANTENNA/CABLE/SATELLITE
IN socket at the back of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for
Note : If you want to receive the signal from your cable or cable
box, please connect a coaxial cable to the ANTENNA/CABLE
IN socket at the back of the TV set.
4. When powered on, the TV will be turned on directly or be in standby
mode.
If the power indicator lights up, the TV set is in standby mode.
Press the button on the remote control or on the TV set to
turn on the TV.
Switching off
To put the TV set into standby mode, press the button on the
remote control. The TV set remains powered up, but with low energy
consumption.
To switch off the TV set, unplug the mains socket from the
mains outlet.
Chapter2 Connections and Setup