LIMIT LIDDT217, Инструкция по эксплуатации

Страница: 9 / 36

The food is too warm.
Interior lighting does
not work.
Unusual noises.
The compressor does
not start immediately
after changing the
temperature setting.
Water on the floor or
storage shelves.
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air-tight
(possibly after reversing the
door).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Please the “Initial Start Up”
section.
refer to
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please the “Installation
location” section.
refer to
Please look in the “changing the
Light Bulb “section.
Carefully warm the leaking
sections of the door seal with a
hair dryer (on a cool setting). At
the same time, shape the warmed
door seal by hand so that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a
period of time.
refer to the “Cleaning and care”
section.
Heavy build-up of
frost, possibly also on
the door seal.
Warning! If the light bulb is
damaged, THE USER MUST NOT
CHANGE IT!
Changing the light bulb by inexperienced
persons may cause injury or a serious
. It must be replaced by a
qualified persons in order to avoid a hazard.
Contact your local Service Force Center for
help.
malfunction
Before changing the light bulb, switch off
the appliance and unplug it, or pull the
fuse or
the circuit breaker.
Light bulb data: 220-240 V,max.15W.
disconnect
To switch off the appliance, set the
temperature regulator to position “0”.
Unplug the mains plug
To change the light bulb, undo the screw.
Press the light bulb cover and slide it
backwards.
Change the defective light bulb.
Refit the light bulb cover and the screw.
Put the refrigerator back into operation.
Changing the light bulb
Bulb
Bulb cover
Screw
Control Box
9