SMAG + MTAG SSI
2. or, on the contrary, you can fasten the sensor to a fixed support and
move the profile of the magnetic tape.
It is customer's duty to evaluate the type of installation that is most suitable for
his application. Anyway both the sensor and the profile (according to your
choice) must be able to slide freely and accomplish a smooth linear travel.
Figure 2
3.3 Sensor (Figure 2)
The sensor can be secured:
1. to a sliding carriage;
2. to an actuator;
3. to a mobile support;
4. or to a fixed support.
Use
four TCEI M4 UNI 5931 type cylinder head screws
inserted from the top
in the holes provided at the four angles of the enclosure. The screws must be 30
mm min. long (see Figure 1).
The maximum tightening torque is 1.2 Nm.
We
suggest adding a few drops of threadlocker of medium bond strength.
The fixing support will be placed at the bottom of the sensor case. Make sure
the cable does not block or hamper the movement of the sensor.
MAN SMAG GA E 1.3.odt
3 – Mechanical installation
10 of 20
