LiGo DORO COMFORT 3005, Инструкция по установке и эксплуатации

Страница: 11 / 21

English
Once these incoming messages have been erased or read this cycle will be repeated. This is
useful when remotely accessing your unit. If there is no answer after three rings, no incoming
messages have been recorded and you can terminate the call before you are charged.
Pin code
The PIN CODE (default=0000) is needed in order to gain access to the remote control
functions of the answering machine. The same code is used for PRIVACY MODE . You can
alter the code, see Setup, p. 1 .
Note!
Using a PIN code prevents other people from accessing your machine without permission. For
security reasons, it is recommended that you change the PIN code from the default setting
of 0000.
Voice
With
VOICE
set to
ON
you will be announced the time for when the incoming message was
recorded. With VOICE set to OFF the time and date will not be announced but you can still
see when the incoming message was recorded in the display.
Answer only
ANSWER ONLY is your announcement message to a caller in which contact information can
be supplied but no incoming message will be recorded. When ANSWER ONLY is selected
A2
is displayed.
Note!
You need to record your own greeting message, there is no pre-recorded message. See Record
outgoing message for instructions on how to record an outgoing message.
"Hello, we are unable to take your call right now. Please do not leave a message as this is
not recorded. Thanks for calling."
Privacy mode
Use privacy mode if you want to prevent unauthorized people from accessing your incoming
messages. With
PRIVACY MODE set to ON you will be asked to enter the PIN CODE before
listening to your incoming messages.
Note!
PRIVACY MODE and remote access uses the same PIN code.
OGM (outgoing message)
The outgoing message is your message to an incoming caller and may be up to 60 seconds in
length. You may want the message to tell the caller that they may start speaking once the
beep is heard after your outgoing message.
"Hello, we are unable to take your call right now, please leave a message after the beep.
Thanks for calling."
Record outgoing message
1. Press and hold . You will hear a short beep, the LED will flash and RECORD OGM is
displayed, do not release until you are done recording.
7