5. Installation
series – Matrix Application Mode – User's Manual
38
5. Installation
series – Matrix Application Mode – User's Manual
38
MA
TRIX APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
Neutrik powerCON TRUE1 Connector
UBEX R-series endpoint devices contains Neutrik powerCON TRUE1 NAC3MPX-WOT power
connector and works with 100 to 240 Volts AC, 50 Hz or 60 Hz power sources.
Connect the Neutrik powerCON to the AC input connector; the extender is immediately
powered on.
See the details about the assembly instructions for the Neutrik powerCON TRUE1 cables on
the website of the vendor:
https://www.neutrik.com/en/product/nac3mx-w-top
5.4.3. Symmetrical Analog Stereo Audio Connector
5-pole Phoenix connector is used for balanced analog audio (line in/out). Unbalanced audio signals can be
connected as well. For asymmetrical output, connect only + and ground. For asymmetrical input c
and ground to the source and connect – to the ground.
Compatible Plug Type
Phoenix
®
Combicon series (3.5mm pitch), type: MC 1.5/5-ST-3.5.
5-pole Phoenix connector pin assignments
See more information about the most common audio cable wiring modes in
section.
You can find more information about audio embedding and de-embedding functions in the
section.
Pin nr.
Signal
1
Left +
2
Left -
3
Ground
4
Right -
5
Right +
5.4.4. RS-232 Connector
UBEX-PRO20-HDMI-F110 model and the Matrix Management Unit contains a 3-pole Phoenix connector
which is used for RS-232 serial connection.
Pin nr.
Signal
1
Ground
2
TX data
3
RX data
RS-232 connector pin assignments
Compatible Plug Type
Phoenix
®
Combicon series (3.5mm pitch, 3-pole), type: MC 1.5/3-ST-3.5.
You can find help for the correct wiring in the
section.
You can find more information about serial interface in the
section.
5.4.5. USB Mini-B Connector
UBEX series devices provide standard USB 2.0 mini B-type connector for software control and
firmware upgrade purpose.
INFO:
The USB control function of the MMU
will be added by future firmware update.
5.4.6. IR Connector
IR detector and IR emitter can be connected to the enpoint device with TRS (Tip, Ring, and Sleeve) connectors.
They are also known as (3,5 mm or approx. 1/8”) audio jack,
phone jack, phone plug, and mini-jack
plug. The pin assignments are the following for the detector
and the emitter:
Detector – 3-pole TRS
Emitter – 2-pole TS
1 Tip
Signal (active low)
1 Tip
+5V
2 Ring
GND
2 Ring
Signal (active low)
3 Sleeve
+5V
3 Sleeve
INFO:
Ring pole of the emitter is optional. If your IR emitter has three-pole TRS plug, then the Ring and the
Sleeve are the same signal (Output - ).
You can find more information about IR interface in the
section.