Page 4 of 13
SC910D/SC910W DMX CONTROLLER
Version 2.1
OWNERS MANUAL
11/02/2020
www.lightronics.com
Lightronics Inc.
509 Central Drive Virginia Beach, VA 23454
757 486 3588
pair data cable(s). One pair carries the data, while the
other pair supplies power to the remote stations.
Multiple smart remotes of different types can be
connected to this bus.
An example using an AC1109 and an AF2104 smart
remote wall station is shown below.
SC910W INSTALLATION
The SC910W (or wall mount) is designed to fit in a
standard 5 gang “new work” style junction box. Be
certain to keep line voltage connections away from the
SC910W and the junction box housing the unit. A trim
plate is included with the SC910W.
SC910W POWER & DMX CONNECTIONS
The SC910W uses an external 12 Volt/3 Amp, DC
power supply, which is included. Connecting power to
a wall mount will require connecting the positive wire
to the +12V terminal and the negative wire to the -12V
terminal on the two pin J1 connector located on the back
of the device.
When making power and DMX connections to the
device, make all low voltage connections and check DC
output prior to mating the connector with the male pins
located on the rear of the SC910W. Do not make any of
the connections with voltage present or while any
devices on the DMX data chain are transmitting.
DMX is installed in a similar way on the removable 6
pin connector J2. The figure below shows the proper
wiring of the power and DMX connections.
SC910W SIMPLE REMOTE CONNECTIONS
The upper five terminals of J3 are used to connect
simple switch remote signals. They are marked as COM,
SW1, SW2, SW3 and COM. The COM terminals are
connected to each other on the printed circuit board.
An example with two switch remotes is shown below.
The example uses a Lightronics APP01 switch station
and a typical pushbutton momentary switch. If the
SC910W simple switch functions are set to factory
default operation, then the switches will operate as
follows:
1.
Scene #1 will be turned on when the toggle
switch is pushed up.
2.
Scene #1 will be turned off when the toggle
switch is pushed down.
3.
Scene #2 will be turned on or off each time the
pushbutton momentary switch is pressed
.
