LightProcessor QCOMMANDER REPLICA, Инструкция по эксплуатации

Страница: 5 / 22

QCommander Replica English, Français, Deutsch, Español
Page 3
SETTING AND ENTERING THE PASSCODE
You may enter a passcode to protect both the RUN and SET menus . When your Replica is delivered,
the passcode 0000 is in place and all menu levels are open. Setting up the passcode with anything
other than 0000 invokes the security system. Any security system in place may be cancelled by
re-instating the passcode 0000.
With SET in the right hand side of the display press the right hand SELECT button. With PSCD in the
right hand side of the display press the right hand SELECT button. Press RUN or SET to choose the
menu to protect. The display now shows 0000. Press PSCD UP DIGIT. Note that after 9 the display
passes back to 0. To select a digit and move to the next, press PSCD NEXT DIGIT. When all four
digits have been set,
MAKE A NOTE OF THE CODE AND PUT IT SOMEWHERE SAFE . Press
PASSCODE ENTER.
You will subsequently need to enter the passcode to go beyond the RUN/SET display when you
select SET.
CARD
The QCommander Replica uses a PCMCIA card, type 1, 512Kb, SRAM. Note that there are various
options available within this specification, such as rechargeable batteries, and these will affect the
price you pay.
The memory cards supplied by LightProcessor are of the rechargeable type. From discharged to fully
charged takes approximately 40hrs. When dispatched from our factory, cards are nominally fully
charged and should be able to store data for up to eighteen months without corruption. However, we
recommend that cards are charged every six months.
To charge a card, insert it in the card slot and select CARD when in the CARD/PSCD display. The
card must be inserted in its slot to perform card operations. If it is not, you will receive an error
message.
Formatting the card
A previously-unused card will need to be formatted before it can receive data. Use the
BACKUP routine described below.
Backing up and Restoring Data
In the RUN/SET display select SET to access the CARD/PSCD display. Select CARD to
access the SYSTEM/DATA display. Select DATA to access the BACKUP/RESTORE display.
To save the Replica’s memory to the card, select BACKUP. At the prompt
‘overwrite card?’ or (‘create new backup card?’ when formatting a new card), press
CARD YES. You will see the message ‘Do not interrupt.’ When you see the message
‘Transfer Done’, press ESC. The Replica will then return to the RUN/SET display.
To upload a card’s contents into the Replica, select RESTORE. At the prompt
‘overwrite memory?’, press CARD YES. You will see the message ‘Do not interrupt.’
When you see the message ‘Transfer Done’, press ESC. The Replica will then return
to the RUN/SET display.
Installing a New Operating System and Changing System Options
In the RUN/SET display select SET to access the CARD/PSCD display. Select CARD to
access the SYSTEM/DATA display. Select SYSTEM to access the OPTIONS/NEW display.
To update the operating system, select NEW. The display prompts ‘Install new
sys?’ Press CARD YES. The system will update and then return to the QREPLICA
display and then RUN/SET.