CONFIGURATION
This mode allows the adjustment of (a) a global fade time, (b) the global hold time and (c) a loss of data
key. Press SCENE TYPE at any time to toggle between (a), (b) and (c). Press
6
to exit configuration
mode. See Fig. 4. The Store must be receiving DMX. To enter configuration mode, press the CONFIG
switch using a thin screwdriver or similar device. The display shows CnF.
GLOBAL FADE TIME
The display shows FAd, followed by the current global fade time expressed in seconds 0-99. Move the
slider to adjust the fade value between 0-0.9 seconds and 1-99 seconds, then press
4
. The display then
shows YES, then the new global fade time.
GLOBAL HOLD TIME
Press
6
to exit configuration mode or SCENE TYPE to adjust the global hold time. The display shows Hld
and then the current hold time. Move the slider to adjust the hold value between 0-0.9 seconds, 1-59
seconds and 1-30 minutes, then press
4
. The display then shows YES, then the new global hold time.
To avoid confusion when setting fade and hold times note the position of the dot in the display, as follows:-
00.1 = one tenth second.
01.0 = one second
1. = one minute
LOSS OF DATA KEY
Press
6
to exit configuration mode or SCENE TYPE to adjust the loss of data code. The display shows
Lod. There are four loss of data keys available. For stand-alone use select Lod 3; for backup use choose
Lod 0,1 or 2.
0 = Blackout. Display shows --- on loss of data.
1 = Hold last valid signal received. Display shows --- on loss of data.
2 = Go to and hold scene 00. Display flashes 00 on loss of data.
3 = Hold the currently selected scene. Display shows scene number on loss of data.
Use the slider to adjust these values, then press
4
. The display shows YES, then the new value.
Press SCENE TYPE to return to fade time adjustment or
6
to exit configuration mode.
Store
LightProcessor DMX Tools, April 2003
Page 6
Move Slider
Move Slider
Move Slider
Press
CONFIG
Display showsFad
(0-99secs.)
Press
Press
Press
Display shows Hld
(0-30mins.)
Display shows Lod
(0-3)
Press SCENE TYPE
Press SCENE TYPE
Press SCENE TYPE
4
4
4
=
Exit CONFIG
6
=
Exit CONFIG
6
=
Exit CONFIG
6
=
Abort
6
=
Abort
6
=
Abort
6
Fig. 4
