Lighthouse SOLAIR 3350, Руководство по эксплуатации

Страница: 37 / 184

Set up the Counter
248083387-1 Rev 10 4-3
The setup process is as follows:
Analog channels are labeled in the settings as A1 through A4. A1 and
A2 correspond to Analog port
1
on the chassis and A3, A4 correspond
to port
2
. A1 and A3 are the first channel and A2 and A4 are the second
channel of these ports. So, if a single-channel sensor is attached to port
1
and is wired to connect to channel one, its data will be displayed on
A1. If it is wired to operate on the second channel, its data will be
displayed on A2.
If a dual-channel sensor, such as the Lighthouse TRH (temperature,
relative humidity) probe, is connected to port
1
, its temperature data
will show up on A1 and its relative humidity data will be displayed on
A2.
The setup process is as follows:
Note:
The screen
examples in this chapter
are for visual reference.
The values displayed may
not be indicative of actual
values.
1. From the MAIN Screen, press the CONFIG button.
2. On the CONFIGURATION screen, press the ANALOG button.
Note:
The Min and Max
values for the Lighthouse
TRH Probe are 0-150. If
using a TRH Probe other
than Lighthouse, please
check the manufacturer’s
specifications for the
correct values.
3. The Analog Configuration Screen displays Figure 4-2.
Figure 4-2 Analog Configuration Screen
4. Press the red “
X
” button to enable an analog channel.