240V AC
Charging
Adaptor
12V DC Charging
Adaptor
Your new LlGHTHOUSE rechargeable CREE LED headlight is perfect for use in and
around the home and garage, providing a safe and portable source of light for use just where
and when you need it. Great for use during power failures, while camping, fishing or working
on the car and many other uses.
Charging the LlGHTHOUSE HAWK headlight
The headlight
must be fully charged for a minimum of 5 hours before being used for the
first time
, this will ensure that the battery gives its best performance now and on future
re-charging cycles. The AC and DC charging adaptors are for re-charging the battery only.
They cannot be used to directly power the headlight. Failure to recharge the headlight every 3
months may permanently damage or reduce the performance of the headlight. The battery
charge does not have to be fully depleted before recharging.
Safety Precautions
Use 240v AC charging adaptor indoors in a dry
location only. Exposure to damp or wet conditions
could cause electrocution or damage to adaptor.
Do not use the charger in the vicinity of flammable
liquids or materials.
Do not use the charging adaptor in combination
with any extension cord, electrical generators, or
step-up transformers.
Always plug the adaptor directly into a 240v outlet
in a suitable location.
Store in dry location and do not allow the charging
adaptor to come in contact with water, rain or snow.
If the charging adaptor comes into contact with water,
place in a dry location at room temperature, on a soft
absorbent towel and allow to dry thoroughly. Do not
operate the unit until it is completely free of moisture.
If the adaptor becomes submerged in water,
discontinue use immediately and contact your local
LIGHTHOUSE retailer for a replacement charger unit.
Do not store charging adaptor where temperatures
may exceed 122°F (50°C).
Use only the AC charging adaptor supplied with the
worklight. Do not attempt to charge the torch with
an adaptor that is not compatible as this could result
in a fire, damage to the torch or personal injury.
Safety Precautions
The DC charging adaptor can be used in most
vehicles by plugging into the 12v DC cigarette
lighter or accessory power socket.
Consult your vehicle owner's manual for further
information on operating 12v DC accessories.
Do not drive the vehicle while charging, as an
unsecured light may be a hazard during certain
driving manoeuvres.
Store in dry location and do not allow the charging
adaptor to come in contact with water, rain or snow.
If the charging adaptor comes into contact with water,
place in a dry location at room temperature, on a soft
absorbent towel and allow to dry thoroughly. Do not
operate the unit until it is completely free of moisture.
If the adaptor becomes submerged in water,
discontinue use immediately and contact your
local LIGHTHOUSE retailer for a replacement
charging adaptor.
Do not store charging adaptor where temperatures
may exceed 122°F (50°C).
Use only the DC charging adaptor supplied with
the headlight. Do not attempt to charge the
headlight with an adaptor that is not compatible
as this could result in a fire, damage to the
product or personal injury.
Using the DC Charging Adaptor
1) Plug the adaptors jack plug into the socket
on the side of the headlight.
2) Plug the adaptor into the vehicles 12v DC
cigarette lighter or accessory power socket.
4) It is recommended that the torch is
not left in
this charging mode for longer than 5 hours
.
Charging should be done with the engine
running to prevent running down the charge
on the vehicles battery
5) When charging is complete, you must
disconnect the adaptor from the car socket
before unplugging the DC jack from the
headlight.
Using the AC Charging Adaptor
1) Move the ON/OFF switch to the OFF position,
failure to place the switch in the OFF position
will prevent the battery from being charged
and may damage or impair the batteries
future performance.
2) Plug the adaptors jack plug into the socket
on the side of the headlight.
3) Plug the adaptor into 240V socket and switch
the socket on (if applicable).
4) Charge the battery for a minimum of 5 hours
before using for the first time, and 3-5 hours
on subsequent recharges.
6) When charging is complete, you must remove
the charging adaptor from the mains socket
before unplugging the DC jack from the torch.
To prevent overheating do not charge for
more than 5 hours.
Rechargeable CREE LED Headlight
Specifications
Battery Pack:
Rechargeable battery:
3.7V, 700-800mA lithium battery
LED Type:
3 Watt CREE LED
Using the Headlight
To turn on full beam, press the on/off button on
the side of the headlight.
Press the button again to switch to half power beam.
Press the button again to switch to strobe mode.
Under optimum conditions, with a full charge,
the headlight can normally be used for 3-4 hours.
To achieve the best performance from your
headlight, always switch the headlight off when
the battery power begins to run low, and recharge
immediately.
Focus Control
The beam may be focused by moving the
front lens forward for a narrow beam or
backwards for a wide beam.
Adjustable Headstrap
The headstrap is adjustable to fit all head
sizes.
Charging
socket
On / Off
Button
Adjustable
Focus
