6
Recharging Your POWERLIGHT RESCUE
Charging via the included AC adapter.
Never use any other charger than the one provide with the unit. Use of another
charger can damage the internal Lithium battery, which could result in fire.
1. Connect the pin jack at the end of the AC adapter cord to the POWERLIGHT
RESCUE through the input port marked “AC IN.”
2. Connect the male end of the AC adapter to the AC outlet.
3. Using this method, the unit will be brought to full charge automatically without
overcharging. It can remain connected to AC power without adverse effect.
Note: The blue status LEDs will turn on successively to indicate charging progress.
When all blue LEDs are lit solid, the unit has reached full charge.
OPERATING INSTRUCTIONS
Used as a 12 Volt Jump Starter
WARNING: The
POWERLIGHT RESCUE
should only be used as a jump
starter with the supplied Safety Cable.
NEVER
use an alternate cable when
jump starting with the
POWERLIGHT RESCUE
.
Note: For optimal performance, do not store your POWERLIGHT RESCUE below 50°F
when using as a jump starter. Never charge or jump start a frozen battery.
Note: When using as a jump starter, make sure that the unit is charged such that the
unit’s Status Display shows 4 blue LEDs when the Power Button is depressed.
1. Use in a well ventilated area.
2. Shield eyes. Always wear protective eyewear when working near batteries.
3. Review this instruction manual and the instruction/safety manual provided by the
manufacturer of the vehicle being jump started.
4. Connect the smart cable/clamp set to the POWERLIGHT RESCUE through the
covered port on the side of the unit. Be sure that the cable connection is fully
engaged and secure. Upon connection, the smart cable will beep and flash all
LEDs as it does its safety check. It will then light a flashing blue LED, indicating
the unit is in standby mode.
5. Turn ignition off before making vehicle connections.
6. Clamp the positive (red +) clamp to the positive terminal on the vehicle battery (for
negative ground system), or an alternate vehicle starting point as recommended
by vehicle manufacturer.
!
