LifeSize Icon Video System Installation Guide
5
For a dual LifeSize Digital MicPod configuration, use the second LifeSize Link cable to connect the first
LifeSize Digital MicPod to the second one.
6.
Insert the cord from the power adapter into the power outlet marked
on the back of the codec.
Insert one end of the power cord into the power adapter and the opposite end into a power outlet on
the wall. See
System Health
for more information about the state of the system as it boots or as
conditions change.
The LifeSize system starts and illuminates an LED on the front of the codec. When the video system
completes the startup process, an initial configuration dialog directs you to configure your system from
a web browser.
If no IP address is assigned to your system, configure the IP address using a directly connected
Ethernet cable between your computer and the system. Read more at
Using a Directly Connected
Ethernet Cable
.
WARNING
To avoid damaging the system, do not disturb or disconnect any of the
connected devices while the system is starting.
7.
Configure the system from a web browser: enter the video system’s IP address, and log in with
administrator credentials. The default username and password are
admin
.
LifeSize recommends changing your password at this time.
For troubleshooting topics, refer to
Troubleshooting Installation Issues
.
Initial Configuration
Refer to the
LifeSize Icon 600 Video System Guide
and the browser-based online help to complete the
initial configuration and for additional configuration steps if your environment uses any of the following:
•
Network Address Translation (NAT)
•
firewall
•
H.323 gatekeepers
•
SIP registrars
•
other network security systems
