LifeSize Gateway-PRI, Руководство пользователя

Страница: 76 / 196

68 LifeSize Gateway User Guide
Configuring Gateway Settings
In the IP Address field, type or edit the peer IP
address.
Note
Two peers cannot have the same IP address or host name/Uniform
Resource Locator (URL).
In the IP Port field, enter or edit the peer IP port
number.
In the Description field, enter or edit the description of
the peer.
Click Upload .
Note
You cannot add a single peer to the Peer list section more than once.
To delete a peer device, select the peer device and click Delete .
Deleting a peer does not cause its active calls to disconnect, but
no new calls are routed to the deleted peer.
Note
The peer hunting process stops when one of the peer devices accepts
the call or when the call is rejected with a disconnect reason. When a LifeSize
Gateway has scanned the
Peer list section and still cannot connect a call, the
following rules apply: if at least one of the peers rejected the call due to
capacity overload, the call rejection reason (towards the call originator) is
“No Resources”; in all other cases, the call rejection reason is “Unreachable
Destination.”
7
In the Peer hunting timeout (sec) field, enter the length of
time (between 1 and 10 seconds) for which the LifeSize
Gateway waits for a Transmission Control Protocol (TCP)
response from each peer device contacted. The default value is
5 seconds.
8 Select the Accept calls from defined peers only check box if
you want the LifeSize Gateway to reject incoming calls from
IP-side entities not defined in the peer list. If deselected, the