11
(89) Bolt (M8x16mm)
6 PCS
(90) Spring Washer (M8)
6 PCS
(91) Washer
(Ø17xØ8.2x1.5)
2 PCS
(92) Curve Washer M8
4 PCS
Step 3
Connect the Sensor Cable II (33) from the Right Handlebar Support Tube (10R) to the
Sensor Cable III (34) from the Handlebar (68). It is recommended to have a second
person assist with this step. One person should hold the Handlebar (68)in place while the
other person connects the sensor cables.
Insert the Handlebar (68) onto the Right and Left Handlebar Support Tubes (10R, 10L)
and secure using three M8x16mm Bolts (89) , three M8 Spring Washers (90), two M8
Curve Washers (92), and one Ø17xØ8.2x1.5 Washer (91). Tighten bolts with 5mm Allen
Wrench with Phillips Screwdriver provided.
Place the
Safety Tether Key (71) onto the Computer (29).
Place the Tablet Computer Holder (70) on the Upper Desk (75).
IMPORTANT:
While sliding the Handlebar (68) onto the Right and Left Handlebar Support
Tubes (10R, 10L), make sure the cables are installed inside the Right Handlebar Support
Tube (10R) and pay attention not to pinch the wires.
NOW
PLEASE FULLY TIGHTEN ALL HARDWARE INSTALLED IN STEP 1 TO STEP 3
WITH THE ALLEN WRENCH PROVIDED.
Hardware:
89
90
92
91
90
89
10L
10R
91
90
89
70
68
34
33
71
75
Tool:
Allen Wrench with Phillips
Screwdriver 5mm
