LifeCore Fitness VST-V8, Руководство пользователя

Страница: 9 / 29

Page | 8
Step 5: Handlebar Assembly
Tools Needed:
5mm Allen wrench
Note: Add the supplied blue loctite in the owner’s
manual bag to the threads of the (J10) bolts for
added support.
A. Only remove the two lower preinstalled (J10)
screws from the left handle bar (E1). Slightly
loosen the top (J10) bolts, but do not remove.
B. As shown in View G) Assemble the left handle bar
(E1) onto the main frame (A). Apply the supplied
blue loctite to the treads of all four (J10) bolts, and
using the 5mm Allan wrench to tighten the four
(J10) bolts firm.
Note: Make sure to tighten handle bar bolts tight
to prevent a clicking noise in the handle bars.
Wiggle the handle bars to help seed bolts in place
and then retighten.
C. Repeat the same steps for the right handlebar
(E2).
Step 6: Central Supporting Tube and Water Bottle
Holder Assembly
Tools Needed:
5mm Allen wrench
6mm Allen wrench
Note: Make sure that all wires are connected
together properly; all (J1) bolts are tight to prevent
a loose central support tube.
A. Connect wires (D1 & D2) from the central
supporting tube (D) to wires (A1 & A2) from the
main frame (A).
B. Slide the central supporting tube (D) onto the
main frame (A). Store excess wires into the tube.
If needed, loosen the preinstalled (J1) screw in
the main frame (A) to help slide central supporting
tube down or to help align holes for the (J1)
screws M8x16.
D. Apply the supplied blue loctite to the treads of
both (J1) bolts M8x16, and using the 5mm Allan
wrench tighten the four (J1) bolts M8x16 tight.
C. Use the two (J6) screws located in the water
bottle holder bag to join water bottle holder (H) to
the main frame (A).