18
Installation and Operation 20/40/60 Minute Timer: 99-DET01
Operating your Lifebreath 20/40/60 Minute Fan Timer
Press and release the Select Button to activate a 20, 40 or 60 minute high
speed override cycle. The Light will illuminate and the unit will run on
high speed ventilation for the selected time. The Light will dim after 10
sec. for run time. The Light will flash during the last 5 min. of the cycle.
The
timer connected to the unit will illuminate for the duration of the
override when the Select Button is pressed.
Lockout
Mode
Lockout Mode is useful if you wish to disable the timers.
The timer can be set to lockout mode by pressing and holding the Select
Button for five seconds. After 5 sec., the Light will flash; release the Se-
lect Button. The timer is now in lockout mode. If the Select Button is
pressed during lockout mode the Light will momentarily illuminate but no
override will be initiated.
Status
Lights
Select Button
initiates high
speed ventilation
for 20, 40 0r 60 min.
Yellow
Red
Green
Red #3
Yellow #4
Green #5
If lockout mode is initiated when the timer is activated, the timer will
continue its timed sequence but will not allow any further overrides to be
initiated. Lockout mode can be unlocked by pressing and holding the Select
Button for 5 sec. After 5 sec. the Light will stop flashing. Release the Select
Button and the timer will now operate normally.
Plug Installation - 130ERV/130ERVR
The plugs are located in the ERV manual bag. The plugs will be installed into the 2 holes
located in the bottom tray of the ERV. They must be inserted from the inside of the unit to
ensure the holes are fully sealed, see detail below.
Ensure the plugs are firmly seated within the foam tray before operation.
Note
Core
Plug
Plug
Foam Tray
Pre-punch hole
Pre-punch hole
Foam Tray
