Smith Machine PL06 Unpacking & Assembly Instructions
9
Assembly Figure 5. Remove the right bar carriage.
5. Remove the right bar carriage.
Have one person take the bar carriage and pull it down
from the top of the PL06. This person will also need to hold down the cable that the
carriage is bolted onto. Have a second person remove the carriage by loosening the eight
bolts (shown in Assembly Figure 5) using a 3/8” combination wrench and a 5/32” hex key
wrench. You may also remove the bar carriage entirely by removing the cable jam nuts
shown in Assembly Figure 8.
6. Insert the bar into the right side carriage.
Swing the carriage out by pulling down on
the cable and slide the bar into the right side carriage. Make sure the bar hooks are
positioned upward as shown in Assembly Figure 6. Insert the bar carriage into the bar
hook as shown in Assembly Figure 6 to hold the bar in place. Retighten the eight bolts
inserting a washer under the bolt.
Assembly Figure 6. Insert the bar into the right carriage and place on bar hook.
