Smith Machine PL06 Unpacking & Assembly Instructions
7
ASSEMBLY
1. Attach the front (small) brace.
With Person 2 holding the left side and Person 3 holding
the right side, secure the front brace (shown in Assembly Figure 1) by sliding the two
bottom bolts through the bottom holes in the front brace (circled in Assembly Figure 1).
Make sure the Life Fitness nameplate is positioned toward the outside of the machine as
shown in Assembly Figure 1. The two bolts have already been inserted through the sides
of the PL06. Tighten these two bolts to stabilize the PL06.
Loosely tighten
the nuts on the
bolts to make attaching the back brace easier.
Insert two 4-1/4” bolts into the top two holes from the
outside
of the machine and loosely
tighten them. The flat washers and end cap washers need to go onto the bolts in the top
holes using the configuration shown in Assembly Figure 2.
Assembly Figure 1. Attach the front brace.
NOTE:
The two lower bolts on the front brace will NOT have washers or
end caps on the head of the bolt.
Assembly Figure 2. Bolt, flat washer, nut, end cap washer and end cap configuration
(typical for both 4” and 4-1/4” bolts).
