IPEX6000TC-F
Install Guide
4
Front and Rear Panels
IPEX6000TC-F Front Panel
1.
Status / Diagnostic LEDs
• POWER:
• ON; device is on
•
OFF; device is off
•
STATUS:
•
ON; device has entered HDMI config mode
•
BLINKING; The device is working in default mode
•
OFF; the HDMI output has been configured as a LOOP output
• VIDEO
• ON; video signal is stable
• OFF; no video signal detected
• LINK TX
•
BLINKING; device is connected to switch and or another device
• OFF; device is not connected to switch or another device
• LINK RX
•
BLINKING; device is connected to switch and or another device
• OFF; device is not connected to switch or another device
•
USB
• ON; the device is powered on
•
BLINKING; This device is linked to another device, and its USB Host port is connected to a USB
host device.
• SYSTEM - for future use
2.
USB B Host Connection
3.
USB HID Device Client Connection
4.
HDMI config mode (Transceiver mode only)
•
Press and hold 5 seconds to enter HDMI config mode
•
Press this button once: when HDMI ports are in normal state, press this button once to switch
the HDMI ports to support local loop out mode; when HDMI ports are in local loop out state,
press this button once to switch the HDMI ports to original normal state i.e. Input, Output
1
2
3
4
