Liberton LMG-206 S, Руководство пользователя

Страница: 4 / 22

INSTRUCTION FOR USE
ASSEMBLING
■ Holding the head,
insert it in the inlet with
one hand, place the
locking knob into the
hole on the side of the
motor housing. Tighten
it clockwise to secure
the head (fig. 1-2).
■ Place the feed screw
into the head, long end
first, by turning the
feed
screw slightly
until it is set into the
motor housing (fig.3).
■ Place the cutting
blade onto the feed
screw shaft with the
blade facing the front
as illustrated (fig.4). If
it is not fitted properly,
meat
will not be
ground.
■ Place the desired
cutting plate next to the
cutting blade, fitting
protrusions in the slots
(fig-5).
■ Support or press the
centre of the cutting
plate with one finger,
then screw the fixing
ring until tight with
another hand (fig.6).
■ Do not over tighten.
Place the hopper plate
on the head and fix into
position.
■ Locate the unit on a
firm place.
■ The air passage at
the bottom and the side
of the motor housing
should be kept free and
not blocked.
MINCINGMEAT
♦ Cut all foods into pieces (sinewless, boneless and fatless meat is
recommended, approximate size: 20 mm x 20 mm x 60 mm), so that
they fit easily into the hopper opening.
♦ Plug in and turn the “R / ON” switch to "ON" position, then turn the
“ON/OFF/Reverse switch to "ON" position.
♦ Feed foods into the hopper plate. Use only the food pusher (fig.7).
♦ After use switch the unit off and unplug it from the power supply.
REVERSEFUNCTION
♦ In case of jamming switch the appliance off by turning the “R / ON”
switch to "R" position and “ON/OFF/ Reverse switch to "R"
position.
♦ Feed screw will be rotating in the opposite direction, and the head
will get empty.
♦ If it doesn't work, switch the unit off and clean it.
6 7