LG UU24WD, Руководство по установке

Страница: 25 / 44

Remote Controller Installation
Installation Manual 25
ENGLISH
Operation unit
ZONE 1 2 3 4
Humidify JET
AUTO
AUTO SWING OPERATION FAN SPEED
Program set
SUB FUNCTION SET TEMP
Room Temp HI
MED
LO Heater
Defrost
Filter Preheat
Out door
Time
Timer
On
Set no. Time
Off
01 03 05 07 09 11 13 15 17 19 21 23
Oper
atio n unit
ZO NE
1
2 3
4
Hu mid
ify
JET
AUT O
AU TO
SW IN
G OP
ER AT
IO N
FA
N SP
EE D
Prog ram set
SU B F
UN CT
ION
SE T T
EM
P
Ro
om Te mp
HI
MED
LO
He ate r
De fro st
Filt er
Pre hea
t
Ou t do
or
Ti
m e
Ti m er
O n
Se
t n o. Tim
e O ff 01
03
05
07
09 11
13
15
17
19
21
23
5feet
(1.5meters)
Direct
Sun ray contact area
no
no
no
yes
Operation unit
ZONE 1 2 3 4
Humidify JET
AUTO
AUTO SWING OPERATION FAN SPEED
Program set
SUB FUNCTION SET TEMP
Room Temp HI
MED
LO Heater
Defrost
Filter Preheat
Out door
Time
Timer
On
Set no. Time
Off
01 03 05 07 09 11 13 15 17 19 21 23
Fig.1 Typical locations for remote controller
Wireless Remote Controller
HOW TO MOUNT ONTO A WALL
HOW TO INSERT BATTERIES
1. Remove the battery cover from the remote
controller.
• Slide the cover according to the arrow direction.
2. Insert the two batteries.
• Be sure that the (+) and (-) directions are
correct.
• Be sure that both batteries are new.
3. Re-attach the cover.
• Slide it back into position.
• Do not use rechargeable
batteries, such batteries differ
from standard dry cells in
shape, dimensions, and
performance.
• Romove the batteries from the
remote controller if the air
conditioner is not going to be
used for some long time.
• Since the room temperature sensor is in the remote controller, the remote controller box should be installed
in a place away from direct sunlight, high humidity and direct supply of cold air to maintain proper space
temperature. Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation
at an average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of the remote
controller LED's, the remote controller should be installed properly as shown in Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
Wired remote controller installation