LG MULTI V IV PRO ARUN080LLS4, Руководство по установке

Страница: 36 / 37

36
E
N
G
L
IS
H
CAUTION
• Air conditioners should not be installed in areas where
corrosive gases, such as acid or alkaline gas, are produced.
• Do not install the product where it could be exposed to sea
wind (salty wind) directly. It can result corrosion on the
product. Corrosion, particularly on the condenser and
evaporator fins, could cause product malfunction or inefficient
performance.
• If outdoor unit is installed close to the seaside, it should avoid
direct exposure to the sea wind. Otherwise it needs additional
anticorrosion treatment on the heat exchanger.
!
• Periodic (more than once/year) cleaning of the dust or salt
particles stuck on the heat exchanger by using water
In case, to install the outdoor unit on the seaside, set up a windbreak
not to be exposed to the sea wind.
- It should be strong enough like concrete to prevent the sea wind
from the sea.
- The height and width should be more than 150% of the outdoor unit.
- It should be keep more than 70 cm of space between outdoor unit
and the windbreak for easy air flow.
Select a well-drained place.
Sea wind
Sea wind
Sea wind
Windbreak
Selecting the location(Outdoor Unit)
If the outdoor unit is to be installed close to the seaside, direct expo-
sure to the sea wind should be avoided. Install the outdoor unit on the
opposite side of the sea wind direction.
Sea wind
Sea wind
Sea wind
Windbreak
• Product Name : Air conditioner
• Model Name :
• Additional information : Serial number is refer to the bar code on the
product.
Product Sales Name / Model Factory Name
ARUx***LLS4 series
x = N, B (Heat pump),
V (Cooling only)
*** = Numeric; (Cooling capacity)
; 080, 100, 120, 140, 160,
180, 200
ARUx220LLN4
x = N, B (Heat pump),
V (Cooling only)
Product information
Airborne Noise Emission
The sound pressure of this product is below 70dB.
** The noise level can vary depending on the site.
The figures quoted are emission level and are not necessarily safe
working levels.
Whilst there is a correlation between the emission and exposure lev-
els, this cannot be used reliably to determine whether or not further
precautions are required.
Factor that influence the actual level of exposure of the workforce in-
clude the characteristics of the work room and the other sources of
noise, i.e. the number of equipment and other adjacent processes and
the length of time for which an operator exposed to the noise. Also,
the permissible exposure level can vary from country to country.
This information, however, will enable the user of the equipment to
make a better evaluation of the hazard and risk.
Model Designation
INSTALLATION GUIDE AT THE
SEASIDE