LG Multi V 5 ARUM080LTE5, Руководство по установке

Страница: 4 / 55

4
ENGLISH
• Do not touch the power switch with wet
hands.
- There is risk of fire, electric shock,
explosion, or injury.
• When the product is soaked (flooded or
submerged), contact an Authorized
Service Center.
- There is risk of fire or electric shock.
• Be cautious not to touch the sharp edges
when installing.
- It may cause injury.
• Take care to ensure that nobody could
step on or fall onto the outdoor unit.
- This could result in personal injury and
product damage.
• Do not open the inlet grille of the product
during operation. (Do not touch the
electrostatic filter, if the unit is so
equipped.)
- There is risk of physical injury, electric
shock, or product failure.
CAUTION
Installation
• Always check for gas (refrigerant) leakage
after installation or repair of product.
- Low refrigerant levels may cause failure
of product.
• Do not install the product where the
noise or hot air from the outdoor unit
could damage the neighborhoods.
- It may cause a problem for your
neighbors.
• Keep level even when installing the
product.
- To avoid vibration or water leakage.
• Do not install the unit where combustible
gas may leak.
- If the gas leaks and accumulates around
the unit, an explosion may result.
• Use power cables of sufficient current
carrying capacity and rating.
- Cables that are too small may leak,
generate heat, and cause a fire.
• Do not use the product for special
purposes, such as preserving foods, works
of art, etc. It is a consumer air conditioner,
not a precision refrigeration system.
- There is risk of damage or loss of
property.
• Keep the unit away from children. The
heat exchanger is very sharp.
- It can cause the injury, such as cutting
the finger. Also the damaged fin may
result in degradation of capacity.
• When installting the unit in a hospital,
communication station, or similar place,
provide sufficient protection against
noise.
- The inverter equipment, private power
generator, high-frequency medical
equipment, or radio communication
equipment may cause the air conditioner
to operate erroneously, or fail to
operate. On the other hand, the air
conditioner may affect such equipment
by creating noise that disturbs medical
treatment or image broadcasting.
• Do not install the product where it is
exposed to sea wind (salt spray) directly.
- It may cause corrosion on the product.
Corrosion, particularly on the condenser
and evaporator fins, could cause product
malfunction or inefficient operation.
• In order to avoid a hazard due to
inadvertent resetting of the thermal cut-
out, this appliance must not be supplied
through an external switching device,
such as a timer, or connected to a circuit
that is regularly switched on and off by
the utility.
!