13 EN
INSTALLATION
4
5
Install the cabinet with a slight tilt (about 1/2”
(12.7mm)) downward on the outside.
Use the bolt and nut to adjust the tilt of the
cabinet.
CAUTION
Do not drill a hole in the bottom pan.
The product is designed to operate with
approximately 1/2” (12.7mm) of water in the
bottom pan. There is no need to add water
if the pan is dry.
●
Screws (Type A)
Cabinet Track Holes
Indoor
Outdoor
about 1/2”
(12.7mm)
Cabinet
3
Loosely assemble each sill support.
Sill Support
Nut
Bolt
If the distance to the outer window sill is
not that deep, you may not need the bolt
and nut.
NOTE
●
Cabinet Installation
1
Open the window. Mark a line on the center
of the inside sill.
Carefully place the cabinet in the window and
align the center hole on the cabinet bottom
front with the center line on the sill.
2
Pull the bottom window sash down behind
the upper guide until It meets the cabinet.
Center Line
Outside Sill
Inside Sill
Center Hole
Inside Sill
Upper Panel
Guide
Window Sash
Do not pull the window sash down so
tightly that the movement of the curtain
panels is restricted.
NOTE
●
Use 2 type A screws to attach a sill support
to the cabinet track holes on one side. Use
the cabinet track holes that will place the sill
support nearest to the outer edge of the sill.
The longer side of the sill support should be
facing outside the window.
Repeat with the second sill support on the
opposite side of the cabinet.
