Operation unit
Humidify
JET
AUTO
Program set
Room Temp
MED
LO
Heater
Defrost
Filter
Preheat
Out door
Time
Timer
On
Set no. Time
Off
01
03
05
07
09
11
13
15
17
19
21
23
Timer
Cancel
Program
Week
Hour
Min
Holiday
SET/CLR
RESET
Plasma
ZONE
1 2 3 4
AUTO SWING
OPERATION
FAN SPEED
SUB FUNCTION
SET TEMP
HI
Plasma
Forced operation
(Tact switch)
20
Forced Operation
Auto Restart Function
Tips for Filter sign LED
PLASMA Purification Operation (Optional)
Operation procedures when the remote control can't be used.
Press the tact switch (Forced operation) for 2 seconds.
If you want to stop operation, press again the tact switch.
In case the power comes on again after power failure on the Forced
Operation mode, the operating conditions are automatically set as
follows:
During Forced Operation, the initial mode continues.
In case the power comes on again after a power failure, Auto Restarting Operation is the function to operate
procedures automatically to the previous operating conditions.
Filter sign lamp (LED) is ON.
If LED indicating filter sign lamp is ON, clean the filter.
After cleaning the filter, press the Timer button and
◀
button of wired remote controller at the same time for 3 sec.
Then filter sign LED is OFF.
Heat pump Model
Cooling Model
Room Temp.
≥
set Temp.-2°C Room Temp. < set Temp.-2°C
Operating mode
Cooling
Cooling
Heating
Indoor FAN Speed
High
set available
set available
Setting Temperature
22°C
set available
set available
1
Press the On/Off button. The unit will
respond with a beep.
2
Open the door on the remote control. Press the
PLASMA air purifying operation ON/OFF button.
Operation will start when the button is pressed and
stop when the button is pressed again.
3
Set the fan speed again with door of the remote
control closed. You can select the fan speed in four
steps-low, medium, high or Auto.
Each time the button is pressed, the fan speed
mode is shifted.
✴
Air purifying operation (PLASMA) with cooling, heating
or any other operations.
1
2
3
