Installation Manual
17
ENGLISH
Wiring Connection
1. Loosen No 1,2 screws of control
box cover.
2. Connect the cable to the
Terminal block as below diagram
3. Secure the cable onto the Control panel with the Clamp cord.
4. If indoor unit's setting is needed, loosen No.3
screw and lift up the PCB. (option: usage of
bottom vanes, limit angle of top vane)
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the
manufacturer of its service agent.
The connecting cable
connected to the indoor and outdoor unit should be complied with the following
specifications (Rubber insulation, type H05RN-F approved by HAR or SAA).
CAUTION
20mm
GN/YL
NORMAL
CROSS-SECTIONAL
AREA 0.75mm
2
(9k12k/18k Btu/h)
1(L)
2(N)
3
Terminal Block of Indoor Unit
Outdoor
W
ARNING:
Make sure that the screws of the terminal are free from looseness.
1
1
3
3
2
2
Terminal Block
Connecting Cable
Clamp Cord
Dip S/W
Description
S/W OFF
S/W ON
S/W 5
Install scene
Exposed
Half
Concealed
S/W 7
Vane
Top+Bottom
Top vane
vane
only
7. Wiring Connection
