19
Humidification cleaning function
ENGLISH
Humidification cleaning function
Humidification cleaning operation
1. Press the button.
2.
Set to the humidification cleaning mode with
Mode button.
•
You cannot set to the desired humidity.
• During the humidification cleaning operation, the humidification is done with fine particle, so
you will not see the spraying.
3. Select the desired wind amount with Speed button.
• Whenever you press the Speed button, it is changed in the order of Auto → Low → Mid →
High → Auto.
NOTE
!
•
When there is no water in the water tank, the no-water lamp is turned on and buzzer
sounds, but the operation does not stop. During the humidification operation, when you
separate the water tank and tray from the product, no-water is turned on and buzzer
sounds also, but the operation does not stop. During the operation, do not separate the
water tank or the tray.
• During the operation, if no-water lamp is turned on, make sure to turn off the power,
separate the water tank, supply water into the water tank, combine with the main unit, and
operate.
•
There are cases not becoming adequate humidity or rising too high according to the area
or state of the installed room
It does not become adequate humidity. --- Operate with higher wind amount.
It is over adequate humidity. --- Turn off the humidification cleaning operation.
4.
After the humidification cleaning operation, when
you turn off the power, press
operation mode
button to change to the cleaning operation and
operate for about 5 minutes.
• The wet humidification filter is dried quickly and
maintained cleanly.
Humidification
filter
